Option allows you to connect a 16 satellites! To do this we need:ĭiSEqC 1.2 - This switch-positioner. The most common configuration is the DiSEqC protocol 1.0 or 2.0 (can be 2 or 4 ports, respectively, can be connected to 2 or 4 satellites), all-purpose converter.ĭiSEqC 1.1 - allows you to switch between the 16 satellites.Įight heads can also be connected by a single switch 0 /12V and two 4/1 DiSEqC. The four variations of the standard have been standardized in February 1998, before the widespread use of digital satellite TV. Therefore, the standard defines this level as 'DiSEqC-compatible' - is compatible with DiSEqC.ĭiSEqC 1.0 - allows you to switch between 4 satellites ĭiSEqC 1.1 - allows you to switch between the 16 satellites ĭiSEqC 1.2 - allows you to control the positioner ĭiSEqC 2.0 - adds a two-way communication mode to DiSEqC 1.0. It does not have 'digital' designation and, in fact, not part of the technology DiSEqC, Tone Burst but the device can operate in a single system with 'real' devices DiSEqC. There are several options for DiSEqC: The lowest level - mini-DiSEqC or Tone Burst. Another exception to the rule: any receiver that supports DiSEqC 1.0, the switch must support and Tone Burst - in fact, half the receivers may not work with this switch. For example, almost all modern digital receiver supports DiSEqC 1.2 (work with positioner) and it does not support DiSEqC 1.1 (to work with an expanded set of switches). Compatibility levels 'down', ie the receiver to support a higher level of working with a peripheral lower level. Each level requires a set of generated /executable commands and features. The standard defines multiple levels, which can run DiSEqC-device. Taking into account the cable loss and allowable error DiSEqC-detector device should continue to operate at lower amplitude to 300mV. DiSEqC commands are sent through the DC voltage using a frequency of 22kHz tone packages (± 20%) and the nominal amplitude of 650mV (± 250mV) at a supply voltage 13 /18V.

Protocol DiSEqC is used to control devices in the receiving system for satellite television. The standard provides compatibility with conventional switching voltage 13/17 volt and 22 kHz tone. Mode communication via cable - single or double-sided, to supply power.

To send the signal using a coaxial cable. DiSEqC (Digital Satellite Equipment Control) -Protocol communication between a satellite receiver and other devices - such as switches, positioners, etc.

Setup diseqc switch